AI-generated illustration for Galileo Whispers of gas transfer from a companion toward a compact accreting star. Relative sizes, colors and the stream are illustrative; no spin-up rate or state-transition timescale is measured.
An old pulsar can spin faster when gas from a companion transfers angular momentum to its neutron star. The gas arrives with orbital motion, usually forms an accretion disk, and interacts with the star’s magnetic environment before some reaches the surface. A sustained positive torque can shorten the rotation period to milliseconds.
This recycling process is different from a pulsar suddenly switching its observed power source. A transition between accretion-powered X-rays and rotation-powered radio pulses can happen quickly even though building a rapidly spinning star takes much longer.
The companion supplies motion as well as mass
A neutron star that has spent time losing rotational energy need not remain permanently slow. In a suitable close binary, its companion can supply matter. Because that matter carries angular momentum, the flow is not simply a straight radial fall.
An accretion disk transports angular momentum between neighboring regions while allowing some gas to move inward. Near a magnetized neutron star, magnetic stresses connect the disk and magnetosphere. If the net torque adds angular momentum in the star’s rotational direction, its angular velocity rises. The relevant accounting is angular momentum, not just added mass.
The Papitto and colleagues study of IGR J 18245–2452 places the observed state changes in this recycling picture. It does not imply that every bit of transferred companion mass is retained or that accretion always produces a positive net torque.
The magnetic boundary regulates access
The disk, the rotating magnetic field and an outgoing pulsar wind compete. A larger inflow can push the boundary inward and support accretion-powered emission. At lower inflow, rotation-powered activity may become observable again. Some transferred material can be expelled instead of settling onto the star.
NASA’s 2014 account of transitional pulsar J 1023 describes the change in the visible system as gas supply and the pulsar environment interact. The light tells observers which processes are active; it is not a direct time-lapse view of the entire recycling history. The pulsar lighthouse overview provides the basic viewing geometry.
One star was seen in both states
For IGR J 18245–2452, observations in 2013 found millisecond X-ray pulsations associated with accretion. Its spin and orbital timing matched a previously known radio pulsar in the cluster M 28. Radio pulses were detected again after the X-ray outburst. That identity match was essential: two nearby sources changing separately would not establish the same connection.
The study therefore supplied direct evidence that a single neutron-star binary could appear in both accretion-powered and rotation-powered states. It also warned that missing radio pulses alone need not prove the radio mechanism is off; intervening material can eclipse or obscure the signal.
Do not confuse a switch with the spin-up history
A practical comparison has three clocks. The spin period measures one turn of the star. A state-change timescale describes a change in accretion or emission behavior. The evolutionary timescale describes the accumulated transfer that recycles the neutron star.
Switching from radio to X-ray activity does not mean that an ordinary slow star acquired its entire millisecond spin during that one outburst. The star was already rotating rapidly when the switch was observed. Repeated accretion episodes over a long binary evolution can build the angular momentum budget, while short transitions reveal how the present-day inflow and magnetosphere compete.
Nor is a glitch the same mechanism: a glitch can redistribute angular momentum already inside a neutron star, whereas recycling supplies it from outside. Those distinctions make a fast pulsar an evolutionary clue rather than a simple indicator of youth.